Right now I have 12 volts to switch but when turned I get nothing at C as far as voltage go. Does C go back to the starter where the battery is? This is the circuit with the neutral switch and PTO switch. I cannot find any other points on the starter except the small one and I am assuming this should go to ground. are not affiliated, sponsored or otherwise connected in any way with the equipment manufacturers. Where does the wire from C terminate to? It looks like the same point on the starter where the voltage regulator and battery are. The parts listed on our website, catalog, publications, etc. On the key switch I have a wire from the starter to terminal B, I have R1-R2 going out to T Stat, BR goes to fuse block. The one on the bottom has several wires on it, I have the battery on it, voltage regulator on it. One is small and is on the side nothing attached to it. There is a relay under ther but not sure for what, there are three wires that could hook up to it but only two connectors. Nothing under dash was hooked up so trying to fix it as well. (When I pulled the dash one wire on the push button start had came unhooked so do not know where it went) the other went straight to starter). I have put a new key switch on it and have a service manual so have figure out most terminations, not sure if it is an aftermarket starter or not but looks like original. A friend of my dads went a little crazy and bypassed the starter and put a push button in, I am putting this back together now and have run into an issue. I have inherited my fathers JD 650 and and it needs some work but runs well.
0 kommentar(er)
